Logging Equipment For Sale

CAT 501HD, 11,699 hrs., CALL

2012 Caterpillar 525C Single arch Winch Rebuilt tranny New top end New injectors New Heui pump 30.5s in pretty good shape 16k hrs Runs and operates good Using daily

CAT 508 Skidder

1993 Caterpillar 518C Grapple Skidder, 13000 hours, 30.5 x32 Tires at 90% Enclosed Cab with Heat, Center Section is Good, Good Chains New Belts and Batteries, Ready for the Woods. Operating Weight 26,510.6lb Overall Length 18.25in Overall Width 11 ft Height To Top Of Cab 9.55ft in Disclaimer The information is the best of our knowledge at the time of the listing. The price may change without notice and additional charges may apply, including freight, taxes, duties, tariffs, quarantine, etc.

Rotobec 4552HD grapple, 32" triple grouser pads, high rise cab, fully operational

CTR 426, crawler trailer, GLK55 grapple, serviced and ready to work.

SH56B saw, 30.5 tires

CTR 426, hydraulic crawler trailer, GLK55 grapple, fully serviced and ready to work.

CTR 426, hydraulic crawler trailer, GLK55 grapple, fully serviced and ready to work.

Various Rebuilt and Used Final Drive Available. TK1051 Final Pictured

This grapple has been reworked in our shop. The grapple has been line bored and the cylinder pin bosses have been fabricated out of new round stock. New pins and bushings through out. Cylinders inspected and repacked. Grapple has been tested. Tight and dry.

FUSION INTERFACE INCLUDE: MILLYARD TOP CLAMP AND CONNECTOR LINES FROM COUPLER TO THE TOOL. LOG & LUMBER FORK 72" Online Owner's Manual REQUIRES:3RD VALVE,CONNECTOR LINES FROM MACHINE TO MACHINE TO COUPLER

Operates, Engine has heavy blowby.

1241 mm (48.8 in) Dual Bale Tines with IT Interface Rate Capacity (2,204 lb) Used for lifting and stacking of hay and straw bales.

COMPATIBLE W/CAT 563 COMPATIBLE WITH CAT & PRENTICE FELLER BUNCHERS Online Owner's Manual TAKE OFF FROM 563 TAKE OFF FROM CAT 563 FB

108” CARRIAGE 72” TINE PIPE FORKS 938H/G PIPE AND POLE FORK GROUP FOR FUSION COUPLER FUSION INTERFACE Online Owner's Manual

18 TEETH ARM HYDRAULICS- CUSHIONED- 32GPM/ 3770 PSI DISC DIAMETER 57IN KERF- 2 5/16 IN Online Owner's Manual SAW HYDRAULICS- 30GPM/ 4500 PSI THROAT OPENING 51.20IN TILT, PARTIAL, AND FULL- 51GPM/ 3770 PSI WIDTH- BASE 67IN. HEIGHT- 115IN. MAX CUT DIAMETER 22.50IN.

FOR USE WITH FUSION QUICK COUPLER GRAPPLE AREA: 1.7 M2 2.03 YD2 Online Owner's Manual OVERALL HEIGHT CLOSED-OPEN: 1620MM (64") - 2664MM (105") OVERALL LENGTH: 1981MM (78") TINE LENGTH 1372MM (54") OVERALL WIDTH: 1800MM (70"), INCL. LINES AND "TURN TO CONNECT" QDS REQUIRES: 3RD VALVE ON MACHINE

Rebuilt and Used CAT 525C, 535C, 545C axles